Description
When installed correctly the system will allow an errant vehicle to be stopped, contained or redirected in a safe manner.
This barrier system in particular provides alternative foundation pile size options with easy installation and zero maintenance.
The Sentryline II TL- 3 and TL- 4 Wire Rope Safety Barrier System can also be easily repaired after impact.
Features
- Tested to NCHRP350 TL-3 and TL-4
- AS3845: 2015 compliant and approved for use by Australian State Road Authorities
- Exceptionally good vehicle control and behaviour
- Can be used on either edge of the road or median application
- Designed to be used with Sentryline Terminal End III NCHRP350 TL-3 anchor
- Can be upgraded from TL-3 to TL-4 easily by the addition of another cable
- Low cost patented technology available exclusively through ACP
Specifications
- All posts hot dip galvanised (powder coating in various colours optional)
- Cable – 19mm 3 x 7 strand pre-stretched by 35%
- TL-3 top cable 770mm from ground
- TL-4 top cable 790mm from ground
- Typically line post footing piles: 300mm diameter x 750mm (0.05m3)
- Length of need from post 5
- Posts 1 – 7 are spaced at 1.5m (LoN is measured 8m from ground anchor)
- The post spacing may vary from 2 to 9m depending on the deflection requirement
- Concrete: 25Mpa
- Tensioned to 25kN at 20°C. (Tension may vary depending on air temperature at the time if installation, see chart in the installation guidelines*)
Brochures
Manuals & Guides
Standards and Approvals
- Sentryline II Wire Rope Barrier Systems have been designed and tested to meet the evaluation criteria of NCHRP 350 Test Levels 3 and 4
- AS3845:2015 compliant
- Approved for use by Australian State Road Authorities.